Sponsored by

Model Trains By Design

Home

Get togethers

How tos

EGT and Boost gauge

Jacobs eBrake

Fix Lose Towing Mirrors

Installing injectors

VP44 Injection Pump Replacement

Brake controller 2003

Last visit:
Times visited:	1
Total hits: Since Feb 22,2005	5213

Warning: fopen(/hsphere/local/home/mdhughes/gatewaydieselownersassociation.com/data/page_hit): failed to open stream: Permission denied in /hsphere/local/home/mdhughes/gatewaydieselownersassociation.com/includes/how_to.php on line 15

Warning: fwrite(): supplied argument is not a valid stream resource in /hsphere/local/home/mdhughes/gatewaydieselownersassociation.com/includes/how_to.php on line 16

Warning: fclose(): supplied argument is not a valid stream resource in /hsphere/local/home/mdhughes/gatewaydieselownersassociation.com/includes/how_to.php on line 17

2003 Brake controller placement How-To.

This how to was written by Michael Hughes.

This page last updated Sun Oct 5 08:52:09 CDT 2003

This is for the Voyager brake controller.

You will need to be a non-smoker for this to work.

Follow the instructions from your brake controller for wiring the connector to the controller.

Remove the ash tray and the ash tray compartment.


	You will need to trim the opening (where you see the wires coming out) to allow for the connector to fit thru.
Slide the controller down as far as it will go. The adjusting knobs will just clean. Now mark where the back mounting holes are. Remove the brake controller and drill holes. Put the controller back in and install two screws, one on each side. Now you need to put a screw thru the ash tray into the ash tray compartment to keep it from moving.
	Install the ash tray compartment. Connect the connector and you are done.

If you have any comments about this how to, please send them to Michael Hughes

Page hit count 831

This site designed and maintained by
MDH IT Services